|
Exact measurement of turned and milled parts |
|
 |
The task:
A device that can perform highly precise measurements of turned parts, and is also able to deal with parts which have troublesome reflecting surfaces. Precision and speed is required, as parts are produced on a mass production scale. The construction must have a minimal foot-print, so that, for example, an image processing system can be incorporated into the system at a later point.
|
|
|
Read more...
|
|
|
Inscription control of bottles and containers |
|
|
Imprints on bottles and similar containers can be reliably tested for readability and verification through the usage of VE 4000 OCV/2. In the course of which, it is irrelevant whether the containers need to controlled whilst in static or continuous motion. Apart from the imprint itself, other factors can be readily monitored and determined, such as label type and position. Through the date function, caption which have inscriptions with the current date can be switch automatically.
|
|
|
Read more...
|
|
|
Isolierglas Prüfen |
|
 |
Glasprüfsysteme für die Isolierglas-Produktion die mehr können:
Der Einsatz von Isolierglas-Prüfsystemen ist bislang nur wenig verbreitet.
Woran liegt das? Bei den heutigen Möglichkeiten der Automatisierung mittels
Bildverarbeitung ist dies auf den ersten Blick unverständlich. Liegen doch
die Vorteile eines automatischen Prüfsystems auf der Hand. Die vollautomatische
Scheibenprüfung wirft jedoch viele Probleme auf, die nur durch intensive,
poduktionsnahe Entwicklung gelöst werden können. |
|
|
Read more...
|
|
|
Short time cycles: Capping montage control of SMD-Diodes |
|
 |
The task:
Sensitive SMD-diodes, bonded to a lead frame, are finally capped before completion. In the course of this, the form must be completely coated with epoxy resin. A lead frame contains 72 diodes before being cut. The inspection time corresponds to 250 ms for 24 diodes. Abnormal diodes are identified, and their position is sent to a SPS unit that is linked to the cutting device for subsequent isolation. The sorting out of good from bad diodes then takes place at an additional location. For these processes, three Smart Cameras are in operation.
|
|
|
Read more...
|
|
|
Lindner Needle Control |
|
|
Needle-tip control during on-going production. Discrepancies relating to deviations from a pre-set design model can be recognised, i.e. the slightest abrasion or surface contamination as well as breakages, etc...
-
Capable of checking up to, or in excess of, 150 units per minute
-
Monitors needle tip movement and sharpness
-
Positioning accuracy of needle tip
-
The control sensitivity can be increased to suit critical or highly specialized designs
|
|
|
Read more...
|
|
|
<< Start < Prev 1 2 3 4 5 6 Next > End >>
|
| Results 11 - 15 of 29 |
